8/24/2023 0 Comments Prtg monitor folder sizeShow Error if younger : Set the sensor to Down status if one of the files in the specified folder is younger than a specific time unit.Show Warning if younger : Set the sensor to Warning status if one of the files in the specified folder is younger than a specific time unit.Show Error if older : Set the sensor to Down status if one of the files in the specified folder is older than a specific time unit.Show Warning if older : Set the sensor to Warning status if one of the files in the specified folder is older than a specific time unit.Don't check : Do not check for the age of the files in the specified folder(s).Specify if the sensor will monitor the folder for certain file ages and show a corresponding status. Trigger 'On Change' notification : The sensor will trigger a change notification if a file changes its timestamp or filename, or if there are new or deleted files.Ignore changes : Changes to the folder will not trigger a change notification.Specify if the sensor will send a change notification when the content of the folder changes. Note: Recursing subfolders in large directories with a high number of branches may evoke timeout errors or performance issues. Monitor the folder and its sub-folders (use with caution!) : Monitor the folder specified above and all of its subfolders.Do not recurse sub-folders : Only monitor the folder specified above and do not monitor its subfolders.Specify if the sensor will include subfolders in the folder monitoring. Note: To monitor shares, the LanmanServer "Server" Windows service must be running on the target computer. The server part ( \\server\ ) is taken from parent device settings of this sensor. If the file is located on a network device, use the Uniform Naming Convention (UNC) path without the server part (you would only enter share\folder ). Please see below for details on available settings.Įnter the full path to the folder this sensor will monitor. For some sensor types, you can define the monitoring target explicitly in the sensor settings. Note: Usually, a sensor connects to the IP Address or DNS Name of the parent device on which you created this sensor. On the details page of a sensor, click on the Settings tab to change its settings. You can change all settings in the sensor's Settings tab later. Therefore, you will not see all setting fields in this dialog. It only shows the setting fields that are imperative for creating the sensor. The Add Sensor dialog appears when adding a new sensor on a device manually. Knowledge Base: What can I do if PRTG doesn't succeed with monitoring a share? PE029 PE032.To monitor files on a share, the "LanmanServer" Windows service must run on the target computer.This sensor counts all files in a folder, including hidden files.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |